Here you will find configuration files to configure your device, you will find set-ups for the most common needs, default watchdog and network monitoring.

Device Testing

This configuration file should be used for testing purposes, it has every event feature enabled and periodic reports every minute, the GPIOs are defined as inputs and will send all reports related to input sense, if you are a developer and need to test the device use this configuration.

Click Here to view file

Asset Monitoring

This configuration file is to track assets and it wont send periodic reports, it will only send reports when the unit detects it started moving, if it doesn't move for a long period of time, the GPIOs are defined as inputs and will report if any change is detected but wont monitor ignition specifically, if it loses GPS or GPRS signal, or if it's battery or main power source has been compromised.

Click Here to view file

Vehicle Tracking

This configuration file intended for basic vehicle tracking, it detects and reports ignition on/off, will send reports periodically every hour when ignition is on but not when it's off, will detect towing, speeding, it will report if the vehicle battery is low or if the device has been disconnected or removed and it wont send any other reports.

Click Here to view file

Fleet Monitoring

This configuration file tries to report any information useful for vehicle monitoring, including, ignition on/off, towing, moving, idle, stop, abandoned, vehicle battery low, device disconnected, speeding, by distance, heading change etc

Click Here to view file